Does one develop a tolerance or hit a limit?

一件制定公或触及跌停？

Nanosecond tolerances on the timing to have it work right.

时间上的纳秒公，让它正常工作。

The majority of samples have no residues or just a fraction of the tolerance level.

大多数样品没有残留物或者只是公等级的一小部分。

There are more than 10 different types of tolerance.

有超过 10 种不同类型的公。

The excessive holding pressure will cause the product to be out of tolerance .

过大的保压会导致产品超出公。

As you know, special detail carries with it special privileges.

你们知道，特别的公有特别的待遇。

The customer agrees to widen up the tolerance .

客户同放大公带。

To achieve such high speeds, the track's flatness was meticulously maintained with a 0.

为了达到如此高的速度，轨道的平整度被精确维护在0.01英寸的公内。

Also, for some precision components, we might require even tighter tolerances.

此外，对于某些精密部件， 我们可能需要更严格的公。

So if we said that the absolute value of Y minus is 2 is less than some tolerance?

那么如果我们说 Y 减去 2 的绝对小于某个公呢？

But could you elaborate a bit more on the specific tolerance values for the electrical components?

但是， 您能否更详细地解释一下电气元件的具体公？

The tolerances for every point of measurement should be clearly specified on the QC inspectors' checklist.

每个测量点的公应在质量控制检查员的检查清单上明确规定。

The DFM should include tolerance analysis.

DFM 中需要包括公分析。

Why do all dimensions have no tolerance?

为什么所有的尺寸都没有公呢？

After testing, we found that a few resistors and capacitors on the PCBA have values outside the tolerance range.

B：经过测试， 我们发现 PCBA 上的一些电阻和电容的超出了公范围。

Draft angle to be within dimensional tolerance unless specified otherwise.

拔模角度无特殊说明，需在公范围内。

Tolerances can vary for different parts of the garment, depending on their significance to the entire piece.

装不同部位的公可能会有所不同, 具体取决于它们对整件装的重要性。

It demands that Apple's operations leaders commit to extremely precise manufacturing tolerances to produce millions of iPhones and other products with squircles.

它要求苹果公司的运营领导致力于极其精确的制造公，以生产数以百万计的 iPhone 和其他带有方圆形的产品。

DFM indicates that the tolerance of this product is too tight.

DFM 表明，这个产品的公太小了。

The returning pin should use positive tolerance.

复位杆应该采用正公。