The second one is going to be terminal multiplexers.

第二个是终端多路器。

Here's  the logic diagram for a simple multiplexer.

这是一个简单多路器的逻辑图。

The remaining 10 bits of the address are sent to the column multiplexer.

地址的剩余 10 位被发送到列多路器。

Any questions for terminal multiplexers, or like, tmux concretely?

对于终端多路器或具体的 tmux 有任何疑问吗？

Multiplexers come in all different sizes, but because we have 16 rows, we need a 1 to 16 multiplexer.

多路器有种不同的尺寸，但因为我们有 16 行，所以我们需要一个 1 到 16 的多路器。

But the fact is there are kind of more convenient solutions to this and this is what a terminal multiplexer does.

但事实上，有一些更方便的解决方案，这就是终端多路器的。

Instead of 8 wires coming out of the multiplexer, we're going to have 128 wires that connect  to these 128-bit buffer locations.

我们将有 128 根线连接到这些 128 位缓冲区位置，而不是只有 8 根线从多路器出来。

Next the 10-bit column address is broken into two  parts, 6 bits are used for the multiplexer, and 4 bits are for the burst buffer.

接下来， 10 位列地址被分成两部分，6 位于多路器，4 位于突发缓冲区。

However, if a row were already open, we  could read or write to any section of 8 memory cells using only the 10-bit  column address and the column select multiplexer.

但是， 如果某一行已经打开，我们就可以仅使 10 位列地址和列选择多路器读取或写入 8 个存储单元的任意部分。

This multiplexer  takes in the 8192 bitlines on the top, and, depending on the 10-bit address, connects a  specific group of 8 bitlines to the 8 input and output IO wires at the bottom.

该多路器接收顶部的 8192 条位线，并根据 10 位地址，将特定的一组 8 条位线连接到底部的 8 条输入和输出 IO 线。

Next, the column select multiplexer uses  the 10-bit column address to connect the corresponding 8 bitlines to the read  driver which then sends these 8 values and voltages over the 8 data wires to the CPU.

接下来，列选择多路器使 10 位列地址将相应的 8 条位线连接到读取驱动器，然后读取驱动器通过 8 条数据线将这 8 个值和电压发送到 CPU。

To convert from an address into something that selects the right row or column, we need a special component called a multiplexer -- which is the computer component with a pretty cool name at least compared to the ALU.

要将地址转换为选择正确行或列的内容，我们需要一个称为多路器的特殊组件——至少与 ALU 相比，这是一个非常酷的名称的计算机组件。