3.Nonpolarized capacitor C1 and potentiometer R2, a linear taper, determine the time constant of integrator IC1B.
无极电容C1线电位器R2决 定积分器IC1B的时间常数。
4.We quantizied the mesoscopic LC circuit, based on the infirmness coupling characteristic of a mesoscopic capacitor .
基于介观电容存在弱耦合,对介观LC电路的量子效应进行了研究。
5.Base on the research of the Low-Voltage in ShunDe power distribution system, according to the principle of comprehensive disposure.
准确便捷地测量配电网系统对地电容电流成该领域研究的热点。
6.Using electrode interface capacitance and surface coverage to investigate the formation kinetics of NS monolayer in hexahydrobenzene solvent.
通过自组装修饰金电极的界面微分充电电容膜的覆盖率考察了NS在环己烷中自组装膜的成膜动力学。
7.Contains symbols for VHF, UHF, and SHF circuit design, including capacitance measurers, nonreciprocal devices, modulators, phase shifters, field polarization devices, and filters.
包含用于甚高、超高高电路设计的符号,包括电容测量器、不可逆设备、调制器、移相器、场极化设备滤波器。
8.Carbon Nanotubes (CNTs) were activated by CO2 and air under different durations, then were used in polarizable electrodes of electric double-layer capacitors (EDLCs).
摘要对碳纳米管粉体在高温下进行空气二氧化碳活化处理,并用于制作双电层电容器极板。
9.The interelectrode dielectric adopts the polypropylene film with surface coarsening which is easy to impregnate so as to enhance the reliability of high-capacity capacitor.
极间介质易于浸渍的表面粗化聚丙薄膜,别提高了大容量电容器的可靠。
10.The Capacitor turns the signal in antiphrasis, the only thing whole. The Earphones do such long ago. The Shot of the handgun not audible.
11.For electrical properties of MOS capacitors, the C-V curves were obtained by LCR meter (HP4284A), and picoampere meter (HP4140B) was used to measure the J-V curves.
12.The capacitive sensor consisted of two mutual insul ating copper and foil electrodes,clinging to the external w all of infusion bottle with two insulating stretch tight balteum.
13.In calefactive phase, the electro thermal model of hot bridge wire was established, the calefactive time of invariable current fire case and capacitance discharge fire case were both studied.
在升温阶段建立桥丝电热升温模型,分别求解恒定电流点火升温时间电容放电点火升温时间。
14.To resolve that, wto-order charging circuit is used to reduce the stretching discharge, and dipulse is used to increase the reliability of the idscharge, which can decrease the failure discharge.