冷却

When thoroughly cooled, pitas can be stored in plastic bags.

完全却后，将面包放到塑料袋内存。

Usually a gas cooler is used between the combustion chamber and hydrator.

通常在燃烧室和水合器之间设一个气体却器。

It's disbennifit to become protected film if change the velocity of flow frequently.

频繁改变水的流速不利于在却器材料表面护膜，而护膜对于防腐蚀是至关重要的。

The cooling unit hasn't come on yet.

却装还未工作。

The heat had to be dissipated by elaborate cooling systems.

热得用复杂的却装散发。

Cooling pumps were left off for more than an hour.

却泵关了一个多小时。

Large quantities of water are needed for cooling purpose.

却要用大量的水。

By that time her enthusiasm had cooled.

到那时她的热情已经却了下来。

Half the number of bolts in floating head of deethanizer overhead cooler were brittle fractured.

气体分馏装脱乙烷塔顶却器浮头螺栓，半数发生脆性断裂。

Leave the cell untouch and let the cell completely cool down.

离开及不要碰那电池, 直至它完全却.

Put the hot broth in the refrigerator for an hour to hasten cooling.

把肉汁在冰箱中放一小时以加快却。

Her passion for her teacher has cooled down.

她对她老师的热恋已经却下来了。

The superconduct-heating tube mentioned in this paper is a new technology with good developmentprospect.

提到的使用热超却模具是一项全新技术,很有发展前景。

This car has a fan-cooled radiator.

这部汽车有台风扇却的散热器。

Indirect cooling circuit via heat exchanger allowing optional heat recovery for the calorifier or cabin heating.

间接排气水却方式，当水流经热交换器时，允许水流经任意方向通过水与废气热交换器或散热箱。

The subcooler is a key device of cryogenic cooling system in High Temperature Superconducting (HTS) cables.

摘要过器是高温超电缆(HTS)低温却系统的关键设备之一。

Don't stow the hairy crab up to the deckhead. You have to keep some space for cooling.

不要把河蟹堆到舱顶，你们必须留一些空间用于却。

The metallographic cooling rate was measured for the Deng Ujimqin mesosiderite using And profile ac concentration vs.

采用剖面中间浓度与镍纹石带宽度关系测定了东乌珠穆沁中铁陨石的金相却速率，其却速率介于0。

The RE(Y)-Mg-Si-Fe nodularizer had been used to cast heavy sectioned high ductile nodular iron cooling wall castings.

应用钇基重稀土镁复合球化剂，铸造厚大断面高韧性球铁却壁，功地获得了铸件中心部位铸态高性能。

For medium and larger horsepower sizes, some manufacturers elect to offer by-pass (pumpage cooled) jacketed motor designs.

对于大中型功率（马力）的电机，一些制造商选择提供旁路（泵却）加套电机设计结构。